|
Safety Precautions
- This appliance is not intended for use
by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
- Children should be supervised to
ensure that they do not play with the appliance.
- If the supply cord is damaged, it must
be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
- Whilst Applicator
is on, care should be taken not to touch nozzle or body forward of inlet
tube as heat builds up quickly.
- If accidental
contact with hot resin should occur, do not try to remove resin. Put burned area of body in cold water
and immediately seek medical advice. Ensure applicator NEVER comes in
contact with water.
- If accidental
contact with hot Applicator should occur put burned area of body in cold
water and immediately seek medical advice. Ensure Applicator NEVER comes
in contact with water.
- Allow Applicator
to cool down completely before storing.
- Unplug cord when
not in use.
NEVER ALLOW RESIN APPLICATOR / GLUE GUN TO COME
IN CONTACT WITH WATER
|
|
Instructions
·
Application area of client’s hair must be freshly
clarified without the use of conditioner. Dry 100%.
·
Wait 10 minutes for the heating chamber to heat up.
·
Insert resin stick through tunnel at back of Applicator. Squeeze
trigger twice until the resin is inside the heating chamber. Wait a further 5
minutes for the heating chamber to heat the resin.
·
If resin is not heated pressure on the trigger to push it
through will result in trigger malfunction. Remember, you cannot force the
resin to melt. It melts during the 5 minutes waiting period whilst in the
chamber.
·
When you are finished using the Applicator, switch off and
unplug leaving any unused resin to remain in the Applicator.
Storage
·
Never remove the remaining resin stick from the
Applicator.
·
Resin left exposed to air will absorb moisture from the
air which causes an annoying (harmless) foaming effect during its next use.
·
Once Applicator has completely cooled down seal the entire
Applicator in an air tight bag and expel the air.
DO NOT REMOVE THE RESIN STICK FROM REAR OF APPLICATOR
AT ANY TIME
|
